玻璃在現在的建筑中，應用越來越廣泛！玻璃施工就離不開方便快捷的打膠機！下面全自動打膠機廠家就給大家普及一下，調試打膠機時有哪些都需要注意的事項！
Glass is more and more widely used in modern architecture. Glass construction is inseparable from a convenient and fast glue beater! The following full-automatic glue machine manufacturers will popularize to you, debugging glue machine when there are what need to pay attention to!
1、在當天機器操作完畢后要把膠管內的膠沖出，防止硬化；如果長時間不實用要注意用煤油清洗膠管和膠槍。
1. After the machine is finished, the glue in the rubber tube should be washed out to prevent hardening. If it is not practical for a long time, we should pay attention to cleaning the rubber tube and gun with kerosene.
2、雙組份打膠機使用的硅酮膠或聚硫膠要注意雜質不能過高，低質量的膠容易堵塞膠管的過濾系統，造成出膠不暢或不均勻。
2. Silicone glue or polysulfide glue used in two-component glue beater should pay attention to the impurities should not be too high, low-quality glue is easy to block the filter system of rubber hose, resulting in poor or uneven glue production.

3、在更換膠的品種時要特別注意把雙組份打膠機內殘留的膠沖凈，應該清洗干凈，因為不同品種甚至的膠容易反應堵塞機器。
3. When replacing rubber varieties, special attention should be paid to rinsing the residual glue in the two-component glue beater, and it should be cleaned, because different kinds or even brands of glue are easy to react to clogging the machine.
4、液壓站系統的壓力，不能調的太高，要根據室內環境溫度等實際情況，調至滿足膠嘴正常出膠均勻打膠即可。打開液壓站時一定要打開膠槍，否則B組份管路壓力將升得很高，造成安全事故。
4. The pressure of hydraulic station system can not be adjusted too high. According to the actual situation of indoor environment temperature, it can be adjusted to meet the normal tapping of rubber nozzles. When opening the hydraulic station, the rubber gun must be opened, otherwise the pressure of component B pipeline will rise very high, resulting in safety accidents.
今天就暫且和大家聊到這里，希望這篇由全自動打膠機的小編整理的知識可以幫助到您，如果您對此還有疑問，詳情請咨詢我們的官方。http://linshi.jncsjx.com
I'm going to talk to you for a moment today. I hope this article can help you. If you have any questions about it, please consult our official for details. Http://linshi.jncsjx.com